Operation; Travel With Platform Lowered; Steering; Levelling Platform - Upright 30sl Betriebsanleitung

060588-026 SL26/30SL
O
PERATION
NOTE: Before operating the work platform, ensure that the pre-operation and safety inspection has been completed,
any deficiencies have been corrected, and the operator has been thoroughly trained on this machine.
W A R N I N G
!
Never operate the work platform with the parking brakes released. Serious injury or damage could
result.
T
R A V E L W I T H
1. Verify Chassis Emergency Stop Switch is in the ON position, pull the button out.
2. After mounting platform, close and latch gate. Check that guardrails are in position and properly assem-
bled with fasteners properly torqued (see Specifications).
3. Check that route is clear of persons, obstructions, holes and drop-offs and is capable of supporting the
wheel loads.
4. Check clearances above, below and to the sides of the platform.
5. Pull Controller Emergency Stop Button out to ON position.
6. Turn Controller Key Switch fully clockwise to start the engine, releasing the key once the engine starts.
NOTE: On Diesel Models, if the engine is cold, depress and hold the glow plug button for six seconds prior to starting
to engage the glow plugs.
NOTE: If the engine does not start on the first try, the Key Switch must be returned to the OFF position before it can be
engaged to start the engine again.
7. Set the Drive/Lift Speed Range Switch to HIGH TORQUE.
8. Grasp the Control Handle so the Interlock Lever is depressed (releasing the Interlock Lever cuts power
to Controller). Slowly push or pull the Control Handle to FORWARD or REVERSE to travel in the
desired direction. The farther you push or pull the Control Handle from center the faster the machine
will travel.
9. While moving, push the Drive/Lift Speed Range Switch to HIGH SPEED for travel on level surfaces or to
HIGH TORQUE for climbing grades or traveling in confined areas.
S
T E E R I N G
Push the Steering Switch RIGHT or LEFT to turn the wheels. Observe the tyres while maneuvering to
insure proper direction.
NOTE: Steering is not self-centering. Wheels must be returned to the straight ahead position by operating the Steering
Switch.
L
E V E L L I N G
With Drive/Level/Lift Switch in LEVEL hold the Control Handle so the Interlock Lever is depressed. Center
bubble in bubble level using Fore/Aft and Left/Right Switches. To level the platform forward it may be nec-
essary to elevate the platform slightly.
R
A I S I N G A N D
1. Position the Drive/Level/Lift Switch to LIFT.
2. While holding the Control Handle so the Interlock Lever is depressed, push the Control Lever slowly to
UP to raise the platform. Pushing the Control Lever farther increases the lift speed. If the platform does
not elevate above the interlock height, about 2,44 m (8 ft.), fully lower platform and re-level.
3. When the work task is completed, position the Drive/Level/Lift Switch to LIFT and lower the platform by
pulling back on the Control Handle until the platform is fully lowered.
Page 8
!
P
L A T F O R M
P
L A T F O R M
L
O W E R I N G T H E
L
O W E R E D
P
L A T F O R M

Operation

Operator Manual