Installation Of Inner Arch Piece - Central Connection Unit Sealing Tape/Connection Of Overhead Shower/Light Transformer - PHARO 29 450 000 Montageanleitung

Installation of inner arch piece – central connection unit sealing
tape/Connection of overhead shower/light/transformer
1 Lead hose of the overhead shower and both light cables
through black rubber sealing tape.
Inner arch piece
screw connection
10 mm
2 Then pull sealing tape approx. 10 mm past the lower end of
(clamp clip (f))
the inner arch piece. The welded seam must be located at the
rear in the middle of the central connection unit. Then screw in
and tighten the last inner arch piece in the clamp clip.
Sealing tape
Sealing
tape
3 Position pipe clamp on overhead shower hose and connect
with overhead shower connection hose.
Tighten pipe clamp.
4 Connect lighting cable (red/brown) of control box light to
white cables of inner arch piece.
Overhead
Light connection
5 Connect black control box light connection cable to the
shower connection
Transformer
power pack with supplied adapter cable.
connection cable
Transformer
adapter
62