Information For Operation; Installation - Weller WSP 80 Betriebsanleitung

1. Description
The Weller micro-solderer WSP 80 features precise and quick heating to the required sol-
der temperature. An excellent dynamic behaviour is achieved using an especially powerful
80W heater element. Together with the slimline form and the simple change of soldering
bits, this soldering iron can be universally used in all situations from extremely delicate sol-
dering to those where there is a greater temperature requirement.
With an integrated grounding connector, there is the possibility for a grounding of the sol-
der bit if required. The anti-static handle and cables mean that the soldering iron satisfies
all requirements of the EGB safety.
Specifications
Connecting voltage:
Power:
Warm up time:
Max. temperature:
Connectable to:

2. Installation

Place the soldering iron in the safety holder. Remove all flammable articles from around the
soldering iron. Plug and lock the connector (7) into the supply unit. Set the required tem-
perature on the supply unit. Wet the soldering bit with solder once it has heated up.
3. Grounding
If required, an grounding of the soldering bit can be created via the supply unit. The connec-
tion possibilities for grounding are described in the instructions for the supply unit.
GB
24V
80 W
approx. 10 sec. (50°C - 350 °C)
450 °C
all 80 W power units

4. Information for Operation

Changing soldering bits
- hold soldering iron horizontal.
- loosen the knurled nut around the bit-sleeve (2).
- pull the bit-sleeve (2) towards the front.
- the soldering bit now sits loosely in the sleeve.
Warning: Soldering bit is HOT!
Do not place or leave the hot soldering tip / calibration tip on the cleaning sponge or on pla-
stic surfaces.
When using a number of different solder bits, it is recommended that the soldering bit and
sleeve are used together as a quick change system.
Keep the heating element and solderin tip heat transfer surfaces clean.
Anti-static plastics containing conducting fillers are used to prevent static charge build-up.
This also means that the insulating properties of the plastic are reduced. No work should
be undertaken on articles which are live, or at high voltage.
The instructions for the use of the supply unit are valid in addition to these here.
5. Accessories
Soldering bits figure LT-Tips see pages 7 - 9.
Subject to technical change without notice!
5