How To Assemble; How To Use - Lionelo Ralf Bedienungsanleitung

6. Play / select / deactivate melodies
7. Time indicator
Remote control (fig. E)
1. ON/OFF key
2. Timer
3. Play melody
4. Volume down
5. Volume up
6. Resume / stop melody
7. Next melody
8. Previous melody
9. Stop rocking
10. Keys from 1 to 5: select rocking speed

How to assemble

1. Insert and screw aluminum feet to the base of the infant swing with screws, and then
put the frame on the base of the product (fig. 1a). Pay attention to correct position of
the shank – its truncated part must face the back of the chair (fig. 1b).
2. Make sure metal fasteners are in a correct place. If you can hear a click, it means the
installation is correct.
3. To remove the frame from the base of the infant swing, press the button at the back
of the frame (A, fig. A) and pull it up.
4. Put the coating on the product, remember to fasten with Velcros.
5. To attach the bow, slide it in a relevant plastic hole in the upper part of the infant swing.
To detach the bow, pull it out after you have slid the button (fig. 8).

How to use

When the installation is finished, connect the product to the source of power or insert
the batteries (fig. 3). Note! The batteries and the power adapter must not be used at the
same time.
Note! While using the product, always use the safety belts (fig. 7).
1. Backrest inclination angle adjustment
To adjust the backrest inclination angle, pull the lever at the back of the frame (A, fig. 4)
and set the desired position. There are two available positions you can choose: lying (A,
fig. 5) and sitting (B, fig.5).
2. Rocking feature
To use the rocking feature, slide down the slider located at the back of the base of the
infant swing (fig. 6). To lock the rocking feature, slide it up.
EN ‑ 8 ‑