3. Please make sure the power adapter complies with the following parameters: 6V DC
1 A. The product must only be connected to linear transformer for toys (compliant
with EN 61558-2-7) or switching mode transformer (compliant with EN 61558-2-16).
Batteries
1. Keep the batteries out of reach of children.
2. Batteries are to be inserted with the correct polarity.
3. Do not throw the batteries into the fire as they may explode.
4. If you do not use the product for a long time, remove the batteries from the holder.
5. Always remove a dead battery. If you keep it inside the product, it may leak or explode
and destroy the product.
6. Non-rechargeable batteries are not to be recharged.
7. Do not mix various batteries or old (worn-out) with new batteries.
8. Do not short circuit battery contacts.
9. Dispose of the batteries in accordance with law; throw them into special containers.
10. Warning! The remote control has button cell batteries which may cause serious internal
chemical burning in case they are swallowed.
11. Warning! The worn-out button cells must be disposed of immediately. Keep new and
worn-out batteries out of reach of children. In case you suspect the batteries have
been swallowed or otherwise placed in any body part, instantly seek medical assistance.
How to install the batteries (fig. B)
1. Remove the battery holder cover by unscrewing it with a screwdriver.
2. Place the batteries inside the holder, pay attention to the polarity of the batteries.
3. Put the holder cover back on and tighten the screw up.
Description of parts (fig. C)
A. Aluminum feet
B. Base of the infant swing
C. Frame of the infant swing
D. Shank
E. Control panel
F. USB cable
Control panel (fig. D)
1. ON/OFF key
2. Volume down / rocking speed down
3. Volume up / rocking speed up
4. Rocking OFF / automatic motion detection OFF
5. Timer – 8 / 15 / 30 minutes
‑ 7 ‑
EN