Mounting With Mounting Clamp; Mounting For Leak Monitoring; Mounting On A Pipe Or Container - Balluff Bcs R08Rre Serie Betriebsanleitung

BCS R08RRE-...
Capacitive Proximity Switches
5
Installation and connection (continued)
5.3

Mounting with mounting clamp

The mounting clamp (BAM02P2) is not included
in the scope of delivery (see Accessories on
page 20).
The sensor can be mounted quickly using a mounting
clamp with snap locks.
Inserting the sensor:
1. Press both gripping surfaces
on the mounting clamp
downwards.
2. Insert the sensor.
Removing the sensor:
1. Press both gripping surfaces
on the mounting clamp
downwards.
2. Remove the sensor upwards.
The fastening tabs can be cut off if necessary.
Removing the fastening tabs:
► Cut off both fastening tabs
using a suitable tool.
12 english
5.3.1

Mounting for leak monitoring

The mounting clamp can be used for leak monitoring.
Mount the sensor at a distance from the floor:
1. Fold over both fastening
tabs.
⇒ This enables mounting at
a distance of 2 mm from
the floor.
2. Mount the mounting clamp
on the surface.
3. Insert the sensor.
5.3.2

Mounting on a pipe or container

The mounting clamp can be mounted on large-diameter
pipes or containers using a strap.
Attaching the mounting clamp:
1. Align the mounting clamp on
the pipe or container.
2. Attach the mounting clamp
to the pipe or container with
two mounting straps.
3. Check that the mounting
clamp is fastened securely.
4. Insert the sensor.