DNIPRO M JS-60 Sicherheits- Und Betriebsanleitung Seite 22

en
discharged and the more charging cur-
rent the jump starter can provide. After
some time, the ammeter will show a small
charging current.
The term "maximum charging current"
means the maximum current that the
jump starter can provide under any cir-
cumstances. This indicator is limited by
the power of the device.
Forced battery charging
Such charging can be carried out with
currents up to 70% of the nominal capac-
ity of the battery, but for a shorter time.
The charging time is shorter, the great-
er the charging current. When charging
with a current of 70% of the nominal ca-
pacity, the duration of charging should
not be more than 30 minutes, at 50% - 45
minutes, and at 30% - 90 minutes.
During forced charging, it is necessary to
monitor the temperature of the electro-
lyte and stop charging when it reaches
45 °C. It should be noted that the use of
forced charging should be an exception,
since its regular use for the same battery
significantly shortens its service life.
WARN ING!
The optimal charging current is ap-
proximately 10% of the nominal ca-
pacity of the battery. If you do not
know the capacity of the battery,
charge it with the minimum possi-
ble current.
After the end of the battery charge
After the end of charging, it is necessary
to adjust the density and level of the elec-
trolyte in each cell of the battery by add-
ing distilled water, after which continue
charging for another 20-30 minutes.
WARN ING!
In the case of reverse polarity or
overload, the protection-burnout
of the fuses is activated. To restore
the operation of the jump starter,
the fuse must be replaced with one
that corresponds to the current in-
dicated on the jump starter body.
22
WA RN IN G!
Do not use homemade fuses. It is
DANGEROUS!
Help when starting the engine
(START mode)
– Turn off the car's ignition and remove
the key from the ignition switch.
– All devices/appliances/functions of the
vehicle that require electricity to oper-
ate must be switched off (for example:
headlights, side and turn lights, radio,
mirrors heating, seats, etc.).
– Connect the RED clip "+" to the pos-
itive pole of the battery, connect the
BLACK clip "-" to the unpainted sur-
face of the non-removable metal part of
the car body away from the fuel lines,
but as close as possible to the battery.
Make sure that the wires do not get un-
der the rotating parts of the engine
mechanisms.
– Reverse wiring may damage the vehi-
cle's battery and/or the vehicle's elec-
tronics.
– Before starting the engine, it is recom-
mended to charge the battery for 15-
20 minutes.
Procedure for starting the car
engine
– Connect the jump starter to the mains.
– Turn on the "START" mode with the
multi-position switch.
– Turn on the car ignition, wait 1-2 min-
utes, start the engine.
– If the engine does not start within 3
seconds, turn off the ignition and take
a break for 30 seconds. Then start the
engine again.
– The number of cycles should not ex-
ceed 5. Then you need to take a break
for 15-20 minutes.
– After starting the engine, turn the ON/
OFF switch or the multi-position switch
to the OFF position.
– Turn off the jump starter from the mains,
disconnect from the battery first the
BLACK clip "-", then the RED clip "+".
– When starting, you can monitor the
starting current with an ammeter.
EU-JS0623001-0623002