DNIPRO M JS-60 Sicherheits- Und Betriebsanleitung Seite 17

damage to the device itself.
– Connect the jump starter only to a pow-
er supply that meets the requirements
of the technical characteristics (see the
"Technical data" section).
– Mechanical damage to the insulation of
the power cord, as well as chemically
active liquids (acids, oil, gasoline, etc.)
are not allowed. In case of damage to
the network cable insulation, contact
the manufacturer (DNIPRO M LLC), the
DNIPRO-M authorised service centre or
the seller of the product for replace-
ment.
Electrical safety
– Fuse replacement and maintenance are
allowed only when the jump starter is
disconnected from both the mains and
the battery. Otherwise, it may cause
electric shock or damage to the device.
– The power wiring must be securely
grounded and have protective devices
- a fuse or an automatic switch.
– In case of damage to the power cable, it
is allowed to replace it only with a net-
work cord that has a similar cross-sec-
tion of wires and insulation. Do not re-
pair the charger yourself, contact the
manufacturer (DNIPRO M LLC), the
DNIPRO-M authorised service centre or
the seller of the product.
– Do not use any power cable extension
cords.
– Make sure that during operation, the
contact clamps of the power cables did
not touch each other, foreign metal ob-
jects and the body of the jump starter.
– Keep battery clamps and terminals
clean.
– Do not confuse the polarity. If you are
not sure about the connection, remem-
ber: most often the positive terminal of
the battery is marked in red and is larg-
er than the negative terminal, and the
negative terminal is connected to the
car body.
– It is forbidden to disassemble the body
of the jump starter, especially when it
is connected to the network. Doing so
may result in electric shock or damage
to the device. The charger should only
EU-JS0623001-0623002
be repaired by the manufacturer (DNI-
PRO M LLC), the DNIPRO-M authorised
service centre or the seller of the prod-
uct.
– During operation, the body of the jump
starter can get very hot. It is forbidden
to cover or hide the ventilation holes on
the body of the jump starter.
Operational safety
– Do not use the jump starter to charge
non-rechargeable batteries or batteries
that are defective.
– Do not allow children and persons with
disabilities to use the jump starter.
– Be sure to read the operating instruc-
tions before use.
– Adjust the jump starter parameters ac-
cording to the battery and vehicle man-
ufacturer's recommendations.
– For reliable contact with the terminals,
before starting charging, clean the bat-
tery terminals well to get rid of oxide.
– The jump starter is not intended for
long-term maintenance-free storage of
the battery. It is forbidden to leave the
jump starter connected to the network
and/or to the battery unattended.
– Disconnect the
the power source immediately after
charging the battery.
– Always monitor the serviceability of the
jump starter. In the event of a malfunc-
tion, the appearance of a smell char-
acteristic of burnt insulation, flames,
sparks, immediately stop working and
contact the manufacturer (DNIPRO M
LLC), the DNIPRO-M branded service
centre or the seller of the product.
– Do not allow the electrolyte to get on
exposed parts of the body, clothing and
the body of the jump starter — there is
a risk of chemical burns and damage to
property.
– If the electrolyte gets on exposed parts
of the body or in the eyes, immediately
wash the affected areas with clean wa-
ter and seek help from a medical facil-
ity.
jump starter from
en
17