VEVOR R95-BMB Bedienungsanleitung Seite 7

8. Insert a new wick inside the wick holder and let the wick
be stuck by the pricks inside the wick holder: The top of the
wick should be evenly exposed by 59mm above the top of the
wick holder.
9. The wick holder lined with a wick is then to be applied down
the wick guide.
10. Get the wick holder in gear with the tip of the wick
adjustment.
11. Turn the the wick adjustment knob clockwise and lift folly.
If the top of the wick is not evenly scissor it even.
12. Put the supporter on the burner-in doing this, the gap
between the supporter and the wick guide should be made
even. Otherwise the vertical movement of the wick will be
hard.
CAUTIONS FOR ASSEMBLERS:
1. In case you feel water or dirt exists in the fuel tank of the heater, you can remove by
turning the tank upside down and then washing it using pure white lighting kerosene.
2. In fitting the wick adjustment, watch not to fasten the wick adjustment nut too tightly.
3. The burner flame rubber packing washer attached to the bottom of the supporter
should never be removed.
4. After assembling the heater, you should test it in a safe place, before using.
6