VEVOR R95-BMB Bedienungsanleitung Seite 5

TO IGNITE:
1. When you are going to use the heater for the first time, you
will fill it with oil and wait about ten minutes until the wick is
soaked with fuel.
2. To ignite, you will:
a. Lift the wick by turning the wick adjustment knob clockwise.
Tilt the chimney by opening the chimney handle.
b. Light the wick with a match in two or three spots.
c. Turn the chimney horizontally using the chimney handle,
thereby setting the chimney properly on the burner.
TO ADJUST COMBUSTION：
If the wire net on top of the chimney is heated bright red, the burner is
working correctly.
If flames flare up over the wire net, it is because the wick is too high.
If the wire net is dark, it is because the wick is too low or fire is short.
TO EXTINGUISH:
1. Turn the wick adjustment knob counter-clockwise slowly until it stops. The wick will
be lowered to the bottom and the fire will be out in 3-5 minutes.
2. Make sure the fire has been extinguished.
3. Never fail to extinguish the fire before you move the heater to another place.
4