VEVOR TC-20 Bedienungsanleitung Seite 17

Compressor
Problem
The Motor Does Not Work.
The Motor Runs, but it
Makes Irregular or Knocking
Noises.
Not Enough Pressure When
Spraying or Painting.
Poor Spray Pattern.
Motor Runs Properly, but No
Air Pressure or Lack of Air
Delivery.
Possible Causes
1. No electrical power.
2. Damaged power cord.
3. The electrical wiring within the
unit is defective.
4. The power switch is defective.
1. The bearing is loose or
damaged. 2. The screws in the
connection rod are loose.
1. Loose air connection(s).
2. The air hose is damaged.
3. The screws on the cylinder
cover are loose.
1. Loose air connection(s).
2. The paint is too thick.
3. The airbrush nozzle is plugged
or dirty.
1. The valve plate is loose or out
of place.
2. The retainer ring is damaged
after excessive use at high
pressure.
- 15 -
Likely Solutions
1. Plug the power cord into a
working, grounded, electrical outlet.
2. Have a qualified service
technician replace the power cord.
3. Have a qualified service
technician- replace the electrical
wiring.
4. Have a qualified service
technicianre- place the power
switch.
1. Have a qualified service
technician replace the bearing.
2. Tighten the screws, or replace
them if necessary.
1. Check all the air connections,
and tighten them if necessary.
2. Replace the air hose.
3. Tighten the screws.
1. Check all the air connections,
and tighten them if necessary.
2. Add paint thinner and mix
thoroughly.
3. Clean or change the nozzle.
1. Open the front cover and make
sure the valve plate is in the
proper position. Tighten the screws
if necessary.
2. Have a qualified service
technician replace the retainer ring.