Safety Instructions - Vevor Rv-5Th-5000 Bedienungsanleitung

WARNING:
Read carefully and understand all instructions before operating. Failure to follow
the safety rules and other basic safety precautions may result in serious personal
injury.
1. Stay alert. Watch what you are doing and use common sense when operating
the tool. Do not use the tool while tired or under the influence of drugs,
alcohol, or medication. A moment of inattention while operating the tool
increases the risk of injury to persons.
2. Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep
hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or
long hair increases the risk of injury to persons as a result of being caught in
moving parts.
3. Do not overreach. Keep proper footing and balance at all times. Proper
footing and balance enable better control of the tool in unexpected situations.
4. Use safety equipment. Wear ANSI-approved safety goggles and heavy-duty
work gloves during use.
5. Do not force the tool. Use the correct tool for the application. The correct tool
will do the job better and safer at the rate for which the tool is designed.
6. Store the tool when it is idle, out of reach of children, and other untrained
persons. A tool is dangerous in the hands of untrained users.
7. Check for misalignment or binding of moving parts, breakage of parts, and
any other condition that affects the tool's operation. If damaged, have the tool
serviced before use. Many accidents are caused by poorly maintained tools.
8. Use only accessories that are identified by the manufacturer for the specific
tool model. Use of an accessory not intended for use with the specific tool
model increases the risk of injury to persons.
9. Avoid off-center loads. If the Pump seems unusually hard to operate,
immediately stop. Adjust the Ram to eliminate or diminish an off-center load.
The Flange Base and Flange Head must only be used together to prevent an
off-center load.
10. Inspect repair after use. Repairs to structural or frame members must be
inspected by a qualified technician to ensure that the structure is still strong

SAFETY INSTRUCTIONS

- 3 -