Fill The Water Tank; Plug In The Stove And Turn It On - Dimplex Optimyst Mpt80 Installations- Und Bedienungsanleitung

Installation
1
Fix the stove to the wall
2

Fill the water tank

3

Plug in the stove and turn it on

8
1. Place product against the wall in the desired
location.
2. Lift up anti-tilt strap on rear of product and mark
location in wall for fixing through the strap.
3. Drill hole in wall using suitable size drill bit for wall
plug provided and fit into the hole fully.
4. Fit the screw provided through the washer, then
through the centre of the strap and tighten fully into
wall plug.
Always ensure that the Optimyst stove is sitting on a
level surface.
Remove the water tank lid by turning it anti-clockwise,
and fill it with clean water.
When screwing the water tank lid back on, be careful
to not over tighten the lid.
Reinstall the water tank into the stove.
NOTE: Only fill the water tank with clean water.
!
This is necessary to produce the flame effect.
Plug the Optimyst stove power cord into
a 13 amp, 230-240 V outlet.
Turn on the power switch on the
cassette and press the standby button
on the stove.
NOTE: Ensure that the power cord
!
is not trapped under the Optimyst
stove as it could cause the cord to be
damaged.
www.dimplexfires.com