Remote Control Operation; Navigation - Dimplex Optimyst Mpt80 Installations- Und Bedienungsanleitung

Operation

Remote Control Operation

!
NOTE: After a power interruption the stove will return to Standby mode and retain the previously used settings.
1 Display Screen
'Menu' Button
2
'Back' Button
3
4 'Advance' Button (ADV)
'Up and Down' Arrows
5
'Enter' Button (Press to
6
Activate the Remote)

Navigation

To use the functions, press menu and use the
selection. Use the or arrows to adjust the setting and press
Sleep Mode
The remote control display turns off when not in use to conserve power. To activate the remote, press
small delay before the screen turns on.
Standby
When it is in standby, the remote will display OFF. Press
ON. Use the arrows to select the standby icon to put it in standby.
Pairing the remote control
Your remote control is already paired with your product from the factory. If it ever disconnects or you get a new
remote, it will need to be paired again. To pair the remote to the fireplace:
1. Open the door and press the rocker switch to the on (I) position. You should hear an audible beep.
2. Press and hold until PAIR appears on the display
3. Bring the remote control close to the product where the receiver is.
4. The product will start to beep and blink
5. Press to complete the pairing process. The product will go into standby mode.
6. To restart product pairing mode at any time, hold the standby button for 3 seconds when in standby mode. The
standby button will flash blue to indicate pairing mode is started and times out after 15 seconds.
1
2
3
6
or arrows until the desired selection is flashing. Press
to select.
to turn it on. When the unit is on, the remote will display
4
5
to confirm
. There is a
11