m-e BELL-520 RX Betriebsanleitung Seite 65

5. After successful pairing, replace
the cover on the wireless motion
sensor.
DELETING A CUVEO RECEIVER
FROM THE WIRELESS MOTION
SENSOR
Please refer to the instructions in
the operating manual of the CUVEO
receiver.
PAIRING A BELL GONG FROM THE
BELL SERIES
1. Pry the cover of the motion
sensor from the lower part.
2. Put a BELL receiver into learning
mode, as shown in its manual.
3. Press the "Learning" button (3)
of the wireless motion sensor to
which the BELL receiver is to be
paired within about 10 seconds
from the start of the learning
process on the BELL receiver. The
BELL receiver will play a melody
and the pairing process has been
successfully completed.
For additional receivers, please
repeat these steps.
After successful pairing, replace the
cover on the wireless motion sensor.
21
EN