m-e BELL-520 RX Betriebsanleitung Seite 64

EN
in 4 levels. Move the switch towards
"H" to activate the wireless motion
sensor during the day.
Move the switch towards "L" so that
the wireless motion sensor is activa-
ted only at night.
LIMITING THE DETECTION AREA
The detection area can be limited
using the detection limiters (4) inclu-
ded in the scope of delivery. To do
this, clip the desired limiter onto the
diffuser lens.
PAIRING A CUVEO RECEIVER
1. Insert two AAA batteries correctly
(observe positive/+ and negati-
ve/-) into the battery compart-
ment.
2. Put a CUVEO receiver into lear-
ning mode (refer to the operating
manual of the respective CUVEO
receiver). This is indicated by a
blinking LED on the receiver.
3. Before the LED on the receiver
stops blinking, press the "Lear-
ning" button (3) of the wireless
motion sensor to which the
CUVEO receiver is to be paired.
The red LED on the receiver will
light up continuously. The pairing
process has been successfully
completed.
4. For additional receivers, please
repeat these steps.
20