m-e BELL-520 RX Betriebsanleitung Seite 66

EN
Note:
Since the signal for BELL receivers
is sent after the signal for CUVEO
receivers, there is a delay of about 1-2
seconds between motion detection
at the transmitter and playback of
the melody at the receiver.
CHANGING THE MELODY OF THE
BELL RECEIVER
To change the melody played by the
BELL receiver, press the "Learning"
button on the transmitter briefly.
This will play the next melody.
Repeat this process until the desired
melody is played. It is then automa-
tically saved.
FUNCTION TEST / OPERATION
Connect a consumer to the paired
CUVEO receiver. For the permissible
maximum power of the consumer,
refer to the "Technical Data" section
of the respective CUVEO receiver.
Walk through the detection area of
the wireless motion sensor. If the
slide switch (2) is on the "moon
symbol," the test is only possible at
twilight or in the dark. The paired
CUVEO receiver should now be
activated for the set time. Any
further motion detection extends
the activation time of the paired
CUVEO receiver.
Note:
The range for detecting motion de-
pends on several factors:
• Mounting height of the wireless
motion sensor
22