m-e BELL-520 RX Betriebsanleitung Seite 63

2. The rear mounting plate has two
mounting holes. Take the moun-
ting plate and mark the moun-
ting holes at the intended moun-
ting location.
3. The wall bracket is fixed to the
wall with 2 screws. Drill the mar-
ked holes and secure the wireless
motion sensor with suitable
screws. (Use appropriate screws
and possibly anchors depending
on the surface)
4. Insert the electronics of the wire-
less motion sensor into the fixed
mounting plate.
5. Reattach the front plate with the
diffuser lens to the electronics
part. It snaps into place and the
wireless motion sensor is ready
for use.
COMMISSIONING
Settings on the motion sensor:
Pry the cover of the motion sensor
from the lower part.
You will find a slide switch (1) at the
bottom for the duration of the ope-
ration of the paired CUVEO receiver.
Times can be set for 5 mins, 30 secs,
15 secs, and 5 secs. If motion is
detected within the sensor's detecti-
on range, the wireless motion sensor
will remotely switch one or more pai-
red CUVEO receivers on and off for
the selected time. Additionally, a pai-
red BELL receiver will play a melody.
If motion is detected by the sensor
again within this set time, the timing
will restart. A paired BELL receiver
will also play a melody.
With the right slide switch (2), the
brightness at which the wireless mo-
tion sensor responds can be adjusted
19
EN