Adjustingtheauxiliaryhandle - Vevor R2103 Bedienungsanleitung

CAUTION!
Ensure the bandsaw is not connected to the mains before mounting to the stand.
・ Disconnect the bandsaw from the mains.
・ Connect the bandsaw to the stand arm 15 by placing the arm fixing bolts 20 ,
washers 21 and fixing washers 22 in the stand fixing holes 8 .
・ Ensure all bolts are tight with the no. 5 Allen key 24 .
CAUTION!
Ensure the bandsaw is not connected to the mains before mounting to the stand.
· Open the guide bar locking screws 5 .
· The guide bar 6 can now be adjusted.
· Tighten the guide bar locking screws to fix the guide bar in place.
• The guide bar 6 can now be adjusted.
• Tighten the guide bar locking screws to fix the guide bar in place.

ADJUSTINGTHEAUXILIARYHANDLE

• To adjust the auxiliary handle 11 loosen the locking nut A using the No. 6 alien key
25 .
• Move the auxiliary handle to the desired position.
• Fix the auxiliary handle in place by tightening the locking nut using the No. 6
alien key.
- 11 -