Switching The Led Light On And Off; Maintenance / Service - Vevor R2103 Bedienungsanleitung

Switching the LED light on and off

Turn on/off the LED light by Switch K.
Cutting Operations
Make sure that the Switch is in the off-position, then plug in the tool.
Secure your workpiece to a workbench or other solid surface.
Make sure the cord is out of the way.
Set the Guide Bar against the workpiece, keeping blade at a 90° angle compared to
the workpiece.
Turn on the Band saw and allow it to come up to full speed before starting the cut.
Adjust speed by turning the speed dial E.
Tilt the unit so that the blade is vertical as shown in. To start a cut, use minimal force
to start a groove. Once groove is started, allow the rest of the blade to cut into
workpiece. Doing this will prevent blade from moving from side-to-side during
cutting.
CAUTION! Do not apply force to the tool by pressing too hard with your
hands or leaning into it. The weight of the tool itself creates enough
force to make a clean cut Forcing or leaning on the tool may twist or
break the blade, damaging the saw and possibly causing injury.As you
reach the end of your workpiece, finish off the cut by slightly raising the
unit slowly, bringing the blade up.

MAINTENANCE / SERVICE

• Protect the tool from impact, shock and grease
• Always keep tool and cord clean (especially ventilation slots I) !
disconnect the plug before cleaning
! do not attempt to clean ventilation slots by inserting pointed objects through
openings
ENVIRONMENT
• Do not dispose of electric tools, accessories and packaging together with house-
hold waste material (only for Ell countries)
-in observance of European Directive on waste of electric and electronic equipment
and its implementation in accordance with national law, electric tools that have
reached the end of their life must be collected separately and returned to an
environmentally compatible recycling facility
- 10 -