HOMCOM 800-265V90 Bedienungsanleitung Seite 4

EN
3. Fill the jug with the required quantity of water (at least 0.5 litres, and a maximum of 1.7
litres). Never fill the water boiler over the "Max". Otherwise the hot water can spatter
out of the base.
ATTENTION: Make sure that you do not spill any water on the base.
4. Pull up the lid handle to open the lid.
5. Place the jug on the base, and insert the plug in the wall socket. Push down the on/off
switch. The on/off pilot light will illuminate.
6. The jug kettle is now switched on, and the water will now begin to heat. The jug kettle
switches off automatically a few seconds after the water has come to the boil. The
on/off pilot light will now extinguish.
7. Remove the jug from the base by the handle, and pour the water out.
ATTENTION: Be carefully you do not contact the hot water. It can cause serious
burning wounds.
8. When you wish to heat the water without it coming to the boil you can switch off the jug
kettle at any time you require.
9. Remove the plug from the wall socket when you have finished using the jug kettle.
Overheating safeguard
The jug kettle is fitted with an overheating safeguard. This will switch off the jug kettle if it
is operated without (sufficient) water. Allow the jug kettle to cool down for at least 10
minutes before using it again.
CLEANING AND MAINTENANCE
Remove the plug from the wall socket, and allow the appliance to cool.
•
Clean the jug with a damp cloth. Never immerse the appliance in water. Never put the
•
appliance in a dishwasher. Make sure that the electrical connections do not become
damp.
If the interior of the jug has become severely discoloured, then the best way to clean it
•
is with a damp cloth and a little washing soda. After cleaning, rinse the jug very
thoroughly.
ATTENTION:
• Never use corrosive or scouring cleaning agents or sharp objects (such as
knives or hard brushes) to clean the appliance.
• Before cleaning, make sure that the appliance is not connected to the power
supply and that it has cooled down.
4