Selector Switch; Speaker Outputs - Peavey Ranger 212 Bedienungsanleitung

PREAMP OUT (7)
The preamp out jack can be used to route the amplified signal to a mixing console, tape recorder, etc. Connect the
preamp output using a shielded cable to an input of the tape recorder, mixer, etc. This patch does not affect the
operation of the amplifier.
IMPEDANCE SELECTOR
Use to select the appropriate impedance of the speakerenclosure(s). If two enclosuresof equal impedance are used, the
switch should be setat one-half of that value (e.g., two 16 ohm enclosures - set switch to 8 ohms; two 8 ohm
enclosures - set switch to 4 ohms). When using only the internal speakers,the Impedance Selector Switch should
be set to 16 ohm.
SPEAKER OUTPUTS
Paralleled 1/4" output jacks for connecting speakerenclosure(s) to the amplifier (minimum 4 ohms). When
using more than one enclosure, be sure to calculate the total impedance and set the impedance switch (9)
accordingly. (See section on Impedance Switch.)
IMPORTANT: Use only high quality, unshielded cable for speakerconnections.
LINE CORD
(120V units only) For your safety,we haveincorporateda three-wire line (mains)cablewith propergrounding
facilities. It is not advisableto removethe groundpin underany circumstances. I f it is necessary to usethe
amp without proper grounding facilities, suitable grounding adaptors should be used. Greatly reduced shock
hazard exists when the unit is operated with the proper grounded receptacles.
INPUTS
PRE AMP
STA
SWITCH (8)
(9)
HANNEL
LEAD EQ
PUSH
LO MID
CLEAN
TUæ
TREMOLO
THIS BLOCK
SHOWS SIGNAL
WITHIN THE UNIT.
ORDER TO THOROUGHLY
UNDERSTAND
FUNCTIONS, PLEASE
STUDY THE BLOCK
DIAGRAM CAREFULLY.
HI
EG
TUBE
MIXER
REVERB
6
DIAGRAM
FLOW
IN
THE UNIT'S
SEND
LOO RETURN
NSONANCE PRESENCE
IMPEDANCE
SWITCH
16.8.4