Peavey RANGER 212 Bedienungsanleitung Seite 5

MASTER VOLUME (20)
Controlsthe overall volume level of the system.Oncea desiredbalanceof thecleanand lead channelvolume levels is
achieved, the entire system level may be increased or decreasedwith the Master Level Control.
STANDBY SWITCH
Allowsamp tobeplaced i n standby o ractive mode. In standby m ode thetubes r emain hot,buttheamplifier i snot
. operational Eliminates w armuptime,allowingthetubes toremain hotandready for instantaneous operation.
STANDBY/ON LED (22)
TheactiveLEDindicator l ightwill illuminate whentheampisin theoperational mode. T hestandby s witch(21)should
be switchedto the active modein order for the ampto be operational.
POWER SWITCH (23)
s Supplie power t otheunit.Depressed tothe"on"position, thepower L EDindicator (24)will illuminate i ndicating
power is being supplied to the unit.
POWER LED/ON (24)
Illuminates w hen AC Power is beingsupplied totheampwhenthepowerswitch(23)is depressed to the"on"
position.
BACK PANEL FEATURES:
34
GROUND SWITCH (1)
position, Three- rocker-type s witchwhich,for mostapplications, should beoperated i n thecenter (zero) p osition. I f
hum ornoise isnoticed c oming fromthespeaker withtheground switch inthecenter p osition, place theground switch
topositive ornegative ( + or-) tominimize h um. S hould a hum]noise problem continue, consult yourauthorized Peavey
dealer,the Peaveyfactory, or a qualified servicetechnician.
NOTE: The ground switch is not functional on 220/240 volt models.
FUSE (2)
A five ampfuseis located withinthecapof thefuseholder. I t mustbereplaced w iththesame typeandvalue
in ordertoavoiddamage t o theequipment andtoprevent v oidingthewarranty. If theamprepeatedly blows
fuses, i t should betaken to aqualifiedservice center f or repair. W ARNING:Thefuseshould onlybe
replaced whenthepowercordhasbeendisconnected f rom its powersource.
REMOTE FOOTSWITCH
Provided for the connectionof the suppliedremotefootswitch (#90000100).Footswitch is usedto selectthe channel
from clean to lead and to select the effect, reverb, and tremolo on or off.
LEVEL (4)
Adjuststhevoltagelevelof theeffectsloop.If thesendlevelis toolow for aparticulareffectsdevice,turnthecontrol
clockwise; if too high, counterclockwise.
EFFECTS SEND (5)
Outputfor supplyingsignalsto external e ffectsor signalprocessing equipment.
EFFECTS RETURN (6)
Inputfor returning signals fromexternal low-level e ffects orsignal p rocessing eåuipment.
NOTE:Signals a resupplied t ooutboard effects o rsignal processing unitsbypatching f romtheeffects s end j ack(5)
output i ntotheoutboard u nit(s)andbackintotheeffects return(6)inputusingshielded cablewith 1/4"phone plugs.
Onlynon-gain effects devices (chorus, reverb, d elay, e tc.)should beused in theeffects loop.Remote (on/off)selection
of outboardeffectsdevicescanbe achievedusing the footswitch.
(21)
5 6
7
JACK (3)
8
9
5