Peavey RANGER 212 Bedienungsanleitung Seite 4

BRIGHT swiTCH (5)
Providesa presetboostto treble frequencies. T o activate,depressthe switch to the "in" position.The bright function
affects only the clean channel.
CLEAN LED (6)
Illuminates green when amp is switched to clean channel.
LEAD LED (7)
Illuminates red when amp is switched to lead channel.
BRIGHT SWITCH (8)
Providesa selectivepresetboostto high frequencies. T o activate,depress the switch to the "in" position. The bright
function affects only the lead channel.
CHANNEL SELECT (9)
Allows selectionof theclean andlead channel.NOTE: Channelselectionmay alsobe accomplishedby theremote
footswitch. If remoteselectionis desiredthe ChannelSelectSwitch must be in the "in" position.
PRE GAIN (10)
Controls the input volume level of the lead channel.
POST GAIN (11)
Controls the overall volume level of the lead channel. The final level adjustment should be made after the desired
sound has been achieved.
LOW, MID and HIGH
Passivecustom tonecontrols that regulatethe low, mid, and high frequencies, r espectively,of thelead channelonly.
SHIFT (13)
Shifts and selectsthe frequenciesat which the mid control operates.
BOOST (14)
Boosts the overall system gain of the lead channel. Depress to the "in" position to activate.
REVERB (15)
Reverberation is an echo effect. Rotate reverb level control
OFE
TREMOLO SPEED (16)
The speedcontrol determinestherate with which the signal is modulated.This control variesthe speedof the tremolo
masteroscillator and shouldprovide any speeddesiredfor modernmusic. Clockwiserotation of the speedcontrol
increasesthe speedof the modulation of the tremolo. The tremolo feature is defeatable from the remote footswitch.
TREMOLO INTENSITY
The intensity control is used to vary the amount of amplitude modulation of the clean signal. It can be adjusted from
barely perceptibleto almost 100%modulation.Clockwise rotation of the intensity control increases thedepthof the
tremolo.
RESONANCE CONTROL
Usedto fine tune thelow frequencyrangeof the speakerenclosureby varying the dampingfactor of the amplifier at
low frequencies.This control canbe setto boostthe gain of thepower amp in the low frequenciesat theresonance/
attenuation point of the speakercabinet to offset low end frequency dropout.
PRESENCE CONTROL
Used to fine tune the high frequency range of the speakerenclosure by varying the damping factor of the amplifier at
high frequencies. This control can be set to boost the gain of the power amp in the high frequencies at the presence/
attenuation point of the speakercabinet to offset high end frequency dropout.
EQ (12)
(17)
(18)
(19)
to increase the effect. Remote footswitch
4
can control ON/