Peavey RANGER 212 Bedienungsanleitung Seite 16

POWER AMPLIFIER
The following specs are measured
@ I kHz with presence and resonance
at O and effects level at 10.
Rated Power & Load:
120 W RMS into 16, 8, or 4 ohms
Power @ Clipping:
Typically @ 5% THD, 1 kHz, 120 V AC line
120 W RMS into 16, 8, or 4 ohms
Frequency Response:
+0, -3 dB, 50 Hz to 20 kHz
@ 100 W RMS into 8 ohms
Hum & Noise:
Greater than 85 dB below rated power
Power Amp EQ:
Active presence: +10 dB @ 2 kHz
Active resonance: +10 dB @ cabinet resonant frequency
Power Consumption:
(Domestic)
400 watts, 50/60 Hz, 120 V AC
PREAMP SECTION
The following specs are measured @ 1 kHz with the
controls preset as follows:
Low/Bass and High/Treble EQ @ 10
Mid EQ @ 10
Bright Out
Boost Out (Lead)
Shift Out (Lead)
Lead Post @ 10
Presence and Resonance @ O
Master Level @ 10
Effects Level @ 10
Reverb @ O
Tremolo/Speed and Intensity @ O
Nominal levels with pre gain/volume @ 5
Minimum levels with pre gain/volume @ 10
Preamp High Gain Input:
Impedance: Very High Z, 470 k ohms
RANGERTM 212 SPECIFICATIONS
SECTION Lead Channel:
(Channel Select In)
Nominal Input Level: -38 V dBV, 12 mV RMS
Minimum Input Level: -67 dBV, .44 mV RMS
Clean Channel:
(Channel Select Out)
Nominal Input Level: -17 dBV, 140 mV RMS
Minimum Input Level: -42 dBV, 8 mV RMS
Maximum Input Level: O dBV, 1.0 V RMS
Preamp Low Gain Input:
Impedance: High Z, 44 k ohms
All levels are increased by +6 dB
Effects Send:
Load Impedance: 47 k ohms or greater
output Level: -10 dBVt0 +10 dBV, 300 mV to 3 V RMS
Effects Return:
Impedance Very high Z, 470 k ohms
Input Level: -10 dBVt0+
Preamp Output:
Load Impedance: 47 k ohms or greater
Nominal Output: +10 dBV, 3 V RMS
Remote Footswitch:
Special 4-button unit with LED indicators, Channel Select,
Effects Loop Bypass, Reverb and Tremolo Bypass
System Hum and Noise @ Nominal Level:
(Clean Channel)
20 Hz to 20 kHz Unweighted
Greater than 75 dB below rated power
Equalization:
Custom Low, Mid and High passive type EQ
Push Bright +6 dB @ 2 kHz
Push Boost increases Gain in midrange
Push Shift (Lead Channel Only) shifts frequency of mid
Cabinet Dimensions:
Height 20"
Length 26"
Depth 11"
Weight Total: 80 lbs.
16
(-6 dB Pad)
10 mVt03 V RMS