VEVOR TCS-200MLA Bedienungsanleitung Seite 11

mete of the scale to get the height result first. If you know your height
well, just follow the next steps.
How to check the height measurement:
Pull out height meter from support hole and straighten the cross-bar.
There are two parts of height meter and it is required to pull out one by
one. When you pull out the first part, it need to ensure all of it fully
pulled out, marbles at the bottom of first part have been out. Then
continue to pull out the second parts until it is mostly out.
Stand on scale base and keep straight , adjust the height meter by
pulling second parts, then make the cross-bar touch the head, and read
the height result from reading position as below picture. It is suggested
to get off scale before reading height result.
6.3 Shut the switch behind displayer, then short press "ON/TARE+"key
to turn on scale, scale starts to self-test, it displays"0.00"after end of
self-test and enter the weighing mode. If it doesn't display "0. 0" or "0.00"
in LCD, please short press "ON/TARE+" key to zero the weight.
6.4 Scale is set in "lb" unit during production, short press "UNIT-" key to
change it into "kg" unit if necessary, or keep it and operate next step
directly.
6.5 Short press "Set" key to enter setting mode, user number flashes,
short press "ON/TARE+" key or "UNIT-" key to adjust the numbers, then
short press "Set" key to confirm. After this, use same way to input
information of gender /age/height in turn.
Till finish inputing the height information and short press "Set" key to
confirm, scale gets into weighing mode again.
6.6 Stand in the center of platform, the weighing result displays after the
stable symbol " " displays at the top left corner of LCD, it is the
stable weighing value, BMI displays accordingly at the same time.