Working Advice - Bosch GCM 10 SD Professional Originalbetriebsanleitung

OBJ_BUCH-1128-002.book Page 47 Tuesday, July 13, 2010 11:27 AM

Working Advice

General Sawing Instructions
For all cuts, it must first be ensured that the
saw blade at no time can come in contact
with the fence, screw clamps or other ma-
chine parts. Remove possibly mounted aux-
iliary stops or adjust them accordingly.
Protect the saw blade against impact and shock.
Do not subject the saw blade to lateral pressure.
Do not saw warped/bent workpieces. The work-
piece must always have a straight edge to face
against the fence.
Long workpieces must be underlaid or support-
ed at their free end.
Position of the Operator (see figure N)
Do not stand in a line with the saw blade in
front of the machine. Always stand aside of
the saw blade. This protects your body
against possible kickback.
– Keep hands, fingers and arms away from the
rotating saw blade.
– Do not cross your arms when operating the
tool arm.
Permissible Workpiece Dimensions
Maximal workpiece sizes:
Mitre/Bevel Angle
Horizontal Vertical
0° 0°
45° 0°
0° 45° (left-
ward)
0° 45° (right-
ward)
45° 45° (left-
ward)
45° 45° (right-
ward)
Bosch Power Tools
Minimal workpiece sizes
(= all workpieces that can be clamped left or
right from the saw blade with the provided
quick-action clamp 21):
145 x 40 mm (length x width)
Cutting capacity, max. (0°/0°): 85 mm
Replacing Insert Plates (see figure O)
The red insert plates 10 can become worn after
long use of the machine.
Replace defective insert plates.
– Bring the power tool into the working posi-
tion.
– Unscrew the screws 59 using the provided
Phillips screwdriver and remove the old in-
sert plates.
– Insert the new insert plates.
– Set the bevel angle to 47° (leftward).
– Push locking lever 41 and completely lower
the tool arm.
– Position the insert plate approx. 2 mm away
from the saw blade. Make sure that the saw
blade does not come in contact with the in-
sert plates throughout the complete possible
ripping length.
– Refasten the insert plate with the screws.
– Repeat the work steps for the other insert
plate in the same manner.
Height x Width
[mm]
85 x 305
85 x 216
50 x 305
32 x 305
50 x 216
32 x 216
English | 47
1 609 929 X04 | (13/7/10)