Bosch GCM 10 SD Professional Originalbetriebsanleitung Seite 42

OBJ_BUCH-1128-002.book Page 42 Tuesday, July 13, 2010 11:27 AM
42 | English
Declaration of Conformity
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 61029 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider Dr. Eckerhard Strötgen
Senior Vice President Head of Product
Engineering Certification
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 14.01.2010
Assembly
Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.
Delivery Scope
Carefully remove all parts included in the deliv-
ery from their packaging.
Remove all packaging material from the machine
and the accessories provided.
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Sliding mitre saw with premounted saw
blade
– Locking knob 12
– Dust bag 1
– Extraction adapter 48
– Open-end spanner 45
1 609 929 X04 | (13/7/10)
– Tool storage 42 with open-end spanner 45,
Allen key 46, and Allen key 47
– Socket spanner/Allen key/
Phillips screwdriver 33
– Quick-action clamp 21
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
Mounting the Locking Knob
(see figure A)
– Screw the locking knob 12 into the corre-
sponding drill hole above the lever 13.
Always tighten the locking knob 12 firmly
before sawing. Otherwise the saw blade can
become wedged in the workpiece.
Stationary or Flexible Mounting
To ensure safe handling, the machine must
be mounted on a level and stable surface
(e. g., workbench) prior to using.
Mounting to a Working Surface
(see figures B1–B2)
– Fasten the power tool with suitable screw
fasteners to the working surface. The holes
17 serve for this purpose.
or
– Clamp the power tool with commercially
available screw clamps by the feet to the
working surface.
Bosch Power Tools