Before Use; Charging The Battery Pack; Inserting/Removing The Battery Pack Into/From The Appliance; Fitting/Removing The Blower Pipe And Flat Nozzle - Parkside Performance Pptlba 40-Li C3 Originalbetriebsanleitung

Before use

Charging the battery pack

CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect
the battery pack to the charger.
WARNING!
► Observe the safety instructions and the in-
structions on charging and correct use given
in the operating instructions for your X20
Team series battery and charger.
A detailed description of the charging pro-
cess and further information can be found
in these separate operating instructions.
NOTE
► The battery is partially charged. Ideally,
charge the battery completely before use.
You can charge the lithium-ion battery at any
time without shortening its service life. Inter-
rupting the charging process does not dam-
age the battery.
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry and the ambient tem-
perature should be between 0°C and 50°C.
► The recommended ambient temperature
range for using tools and batteries is between
-5°C and 50°C.
♦ If necessary, remove the battery packs 2 from
the appliance.
♦ Insert one or two battery packs 2 into the
dual high-speed charger r.
♦ Insert the mains plug into the mains socket.
PPTLBA 40-Li C3
♦ When charging is complete, disconnect the
dual high-speed charger r from the mains and
remove the respective battery packs 2.
♦ Switch off the dual high-speed charger r for at
least 15 minutes between successive charging
sessions. Also disconnect the mains plug.
Inserting/removing the battery
pack into/from the appliance
Inserting the battery pack
♦ Allow both battery packs 2 to click into
the appliance (see Fig. A).
Removing the battery pack
♦ Press the release button d and remove the
battery pack 2.
Fitting/removing the blower
pipe and flat nozzle
WARNING!
► Always switch off the appliance and remove
the batteries 2 before carrying out any
work on the appliance.
► Never use the leaf blower without the attach-
ment fitted. There is a risk of personal injury!
NOTE
► Ensure that the blower pipe 4 is fitted cor-
rectly; otherwise, the appliance cannot be
started.
► The appliance can be adjusted to your indi-
vidual working height using the 3 positions.
You should always work with the blower
pipe 4 as close to the ground as possible.
GB │ MT │ 71 ■