Storage; Disposal And Recycling - Scheppach Lbh3500P Originalbetriebsanleitung

Secure the product on the transport vehicle against
rolling, slipping or tipping over.

13. Storage

• Clean and maintain the product every time before
storage (see chapter "Cleaning and maintenance").
• Store the product in a safe, dry, frost-free, well-ven-
tilated place protected from the weather and out of
reach of children.
• Outdoor storage is not advisable. Also secure the
product from unauthorised access.
• Empty the fuel tank.
WARNING
Do not remove the petrol in enclosed spaces, near fire
or when smoking. Petrol fumes can cause explosions
and fire.
• Start the engine and let it run until the remaining
petrol is used up.
WARNING
Store the product in a dry location, far away from po-
tential sources of ignition, such as furnaces, hot water
boilers with gas, gas dryers, etc. - Fire hazard!
If you store the product for longer than 30 days, it
must be prepared ahead of time. Otherwise, the re-
maining fuel in the carburettor will evaporate and
leave a rubbery sediment behind. This could make
it difficult to start and result in expensive repair work.
1. Slowly remove the fuel tank (22) cap (23) to re-
lease any pressure in the tank.
2. Carefully empty the fuel tank (22). Only empty the
tank outdoors or in well-ventilated rooms. Make
sure that no fuel gets into the soil (environmental
protection). Use a suitable surface.
3. Start the engine and let it run until it stops in order
to remove the fuel from the carburettor.
4. Allow the engine to cool down (approx. 5 minutes).
5. Remove the spark plug connector cover (17).
6. Remove the spark plug connector (30) from the
spark plug.
7. Remove the spark plug.
8. Add 1 teaspoon of clean two-stroke oil through the
spark plug bore hole and into the combustion chamber.
9. Pull the start pull cord (20) slowly several times to
coat the internal components.
10. Re-insert the spark plug.
Recommissioning
1. Remove the spark plug.
2. Pull the start pull cord (20) quickly to remove ex-
cess oil from the combustion chamber.
3. Clean the spark plug and check that the electrode
gap on the spark plug is correct is correctly set, or
insert a new spark plug with the correct electrode
gap.
4. Prepare the product for operation.

14. Disposal and recycling

Notes for packaging
You can find out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the device, the fuel tank and
the motor oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in an
environmentally friendly manner.
www.scheppach.com
The packaging materials are
recyclable. Please dispose of
packaging in an environmen-
tally friendly manner.
GB | 35