Table Of Error Messages: Active Touch Control Panel - Steelcase Ology Desk & Bench Kurzanleitung

5 Errors and malfunctions
Signal/Code
Flashing red
EN
Flashing green
5.2.3 Table of error messages: Active Touch control
panel
Signal/Code
HOT
26
Message
operation
The system is not
correctly connected
Warning – System
error
System is booting
The system is being
reset
Duty cycle
exceeded
Collision detected
(ISP)
Message
The overheating
Required measure(s)
as usual
Instructions on how to
correctly connect the system
can be found in the DM
system manual
Release all buttons and wait
5 seconds. Then try to
repeat the action.
Disconnect the DM system
from the power supply.
(If a power lift is used)
disconnect the power lift
from the mains. Check the
power supply system for
overheating. Let it cool if
required. Check all cable
connections and re-connect
the system.
If the problem persists:
Perform a "manual reset".
Contact LOGICDATA.
To carry out any subsequent
steps wait, until the LED is
no longer flashing. Do not
press any buttons!
Remove the obstacle from
the desk system. Remove
any unnecessary loads from
the desktop. The DM system
can be used as usual.
Required measure(s)
Wait until the overheated