Fault Rectification Table; Table Of Error Messages: Simple Touch Control Panel - Steelcase Ology Desk & Bench Kurzanleitung

3.
Reconnect the control panel to the power supply.
4.
Wait 10 seconds.
ü
The control panel is ready for operation.
The tables below should help you to determine the cause and
correct the error or fault.

5.2.1 Fault rectification table

Error description
Desk does not move up
or down
Desk only moves down
The control panel is not
working
5.2.2 Table of error messages: Simple Touch control
panel
Signal/Code
Lamp not lit
Cause of error
The system is not connected. Make sure the system is
The actuator is not correctly
connected.
Faulty plug-in connection.
The actuator is defective.
The control panel is
defective.
A power outage occurred
while the desk was moving.
The drive unit was dis-
connected while the device
was in motion.
Reset required.
The actuator is defective.
The control panel is
defective.
Message Required measure(s)
Normal system The DM system can be used
5 Errors and malfunctions
Error rectification
properly connected to
the power lift.
Make sure the actuator is
properly connected to all
system components.
Make sure all plug-in
connections are
connected properly.
Replace the actuator.
Replace the user
interface.
Perform a position reset.
Replace the actuator.
Replace the user
interface. Contact the
manufacturer if the
problem persists.
EN
25