Steelcase Ology Desk & Bench Kurzanleitung Seite 20

4 Operating and adjusting
Manual reset of desktop
Releasing the control panel before the process is
completed will interrupt the manual resetting
process and it must be started anew.
Resetting to factory settings
EN
This function can be used to reset the system to the factory
settings.
Configuring memory positions
20
2. Release the rocker.
3. Press and hold the rocker down again.
4. The resetting and initialisation process is starting.
The desk moves slightly downwards and then
upwards again.
5. Release the rocker.
ü The resetting and initialisation process is complete.
1. Press and hold the rocker down and release in the
following order:
}
Rocker 3x down, then rocker 1x up and rocker
1x down with a delay of half a second between
pressing the rocker.
=
--- followed by flashing 0 appears on the display.
ü The system has now been reset to the factory
settings. It is now in the same condition as when it
was first commissioned.
1. Lift the rocker or press it down until the desired
height is reached.
=
The display indicates the desk height (e.g. 73 cm).
2. Press the multifunction button.