Steelcase Ology Desk & Bench Kurzanleitung Seite 18

4 Operating and adjusting
Manual reset of desktop
Wait for 5 seconds if the desk has just been connected to the
mains.
EN
Releasing the control panel before the process is
completed will interrupt the manual resetting
process and it must be started anew.
Resetting to factory settings
This function can be used to reset the system to the factory
settings.
18
1. Press and hold the rocker down.
=
The lower end position is reached.
2. Release the rocker.
3. Press and hold the rocker down again.
4. The resetting and initialisation process is starting.
The desk moves slightly downwards and then
upwards again.
5. Release the rocker.
ü The resetting and initialisation process is complete.
1. Press and hold the rocker down and release in the
following order:
}
Rocker 3x down, then rocker 1x up and rocker
1x down with a delay of half a second between
pressing the rocker.
=
The LED starts flashing green.
ü The system has now been reset to the factory
settings. It is now in the same condition as when it
was first commissioned.