Removing The Scanner From The Lanyard - Werock Rockscan W100 Betriebsanleitung

Rockscan W100 User Manual

Removing the scanner from the lanyard

To remove the lanyard from the Rockscan W100, proceed as follows:
1. Detach the loop on the clip from the lanyard by pressing the two latches on the side inwards and then
pulling the loop off.
2. Use a pointed object, such as tweezers or a needle.
3. Pass the item through the loop that secures the lanyard to the Rockscan W100.
4. Extend the loop so that you can move it over the clip.
215 / 231