General Settings - Werock Rockscan W100 Betriebsanleitung

Note: The virtual COM port must be set to the following parameters:
•
Baud rate: 115200
•
Stop Bit: 1
•
Data bits: 8
•
Parity: without
Scan the following barcode to activate SPP mode:

General settings

Note: Make sure that the base station and the scanner are connected to each other in order to successfully
scan the setup code.
Switching sound on and off
You can switch the base station's feedback sound on or off.
Sound on
Sound off
Switching DATA-LED on and off
You can switch the data transfer LED on or off.
Rockscan W100 User Manual
Bluetooth SPP Mode
207 / 231