Connecting The Scanner; Selecting The Transmission Mode - Werock Rockscan W100 Betriebsanleitung

Rockscan W100 User Manual
To switch off the scanner, proceed as follows:
1. Press the trigger on the scanner or the connected wearable for about 6 seconds
2. The green light lights up once and the device vibrates briefly. Depending on the setting, you will also
hear a sound.
Disable switching off via trigger button
If you do not want the Rockscan W100 to be switched off via the trigger button, scan the following barcode:
The Rockscan W100 now only switches off via the automatic switch-off function when not in use if this
barcode has been scanned.
To reactivate switching off via the trigger button, scan the barcode again.

Connecting the Scanner

This chapter describes how to connect the Rockscan W100 barcode scanner to a computer, smartphone,
tablet or other compatible Bluetooth-enabled device.

Selecting the transmission mode

The Rockscan W100 barcode scanner supports various transmission modes. This chapter describes the
features and how to switch the scanner to the respective mode.
You can see which mode the Rockscan W100 is currently using by looking at the status LED. Depending
on the mode, a different flashing pattern is displayed when the Rockscan W100 is waiting for pairing. The
meanings of the various LED indicators can be found under " Operating and display elements" in the "Status
indicators" section.
143 / 231