Attaching The Scanner To The Lanyard - Werock Rockscan W100 Betriebsanleitung

Attaching the scanner to the lanyard

To attach the lanyard to the Rockscan W100, proceed as follows:
1. Detach the loop on the clip from the lanyard by pressing the two latches on the side inwards and then
pulling the loop off. This will make the following steps easier.
2. Use something very thin and flexible, such as sewing thread, thin wire, or similar. It must fit easily
through the recess at the corner of the Rockscan W100.
Rockscan W100 User Manual
210 / 231