Nfc Mode (Tap & Pair) - Werock Rockscan W100 Betriebsanleitung

Bluetooth HID Modus (Human Interface Device)
The Rockscan W100 emulates a keyboard and sends the scanned barcodes character by character as
keyboard inputs to the connected device. This mode is compatible with a wide range of devices that support
keyboard inputs, such as laptops, tablets, smartphones, and POS systems, and does not require any
additional drivers or programs to use. However, HID mode has limited functionality, as only barcodes can be
transmitted as keyboard inputs. This means that only the characters of the keyboard layout set on your
device can be displayed. Some special characters may not be displayed or may be displayed incorrectly.
Note: To ensure that characters are transmitted correctly, you must set the "keyboard language" of the
Rockscan W100 to the same language used by your operating system. You will find the appropriate
barcodes for configuration in the
Scan the following barcode to activate HID mode:
Bluetooth SPP Modus (Serial Port Profile) – COM Port Emulation
The Rockscan W100 establishes a serial connection to the connected device and sends the scanned
barcodes as a data stream via a virtual serial interface. This mode allows maximum flexibility, as the data is
transmitted unprocessed. However, an application is required that can process the data and access the
virtual serial interface. Therefore, this mode is not compatible with all devices.
Note: The Bluetooth device must support the SPP profile to use SPP mode. If in doubt, consult your
device's user manual for more information.
Scan the following barcode to activate SPP mode:
Bluetooth BLE Modus (Bluetooth Low Energy)
The Rockscan W100 uses energy-saving Bluetooth Low Energy (BLE) technology to send data to the
connected device. The advantage is lower energy consumption, which is ideal for mobile devices with limited
battery life, but this reduces the wireless range.
Note: The Bluetooth device must support the BLE profile to use BLE mode. If in doubt, consult your device's
user manual for more information.
Scan the following barcode to activate BLE mode:
NFC mode (Tap & Pair)
The scanner supports fast pairing ("Tap & Pair") and connection with NFC-enabled cell phones or devices.
Rockscan W100 User Manual
language settings.
Bluetooth HID Mode*
Bluetooth SPP Mode
Bluetooth BLE Mode
144 / 231