Replacing The Lamp - JUNO JB096B5 Benutzerinformation

6. Turn the two fasteners by 90° and
remove them from their seats.
7. First lift carefully and then remove the
glass panels one by one. Start from the
top panel.
1
8. Clean the glass panels with water and
soap. Dry the glass panels carefully.
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence.
Make sure that you put the glass panels (A,
B and C) back in the correct sequence. The
middle panel (B) has a decorative frame.
The screen-printing zone must face the
inner side of the door. Make sure that after
the installation the surface of the glass
panel frame (B) on the screen-printing
zones is not rough when you touch it.
90°
2
A B C
Make sure that you install the middle panel
of glass in the seats correctly.

Replacing the lamp

Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
WARNING! Danger of
electrocution! Disconnect the
fuse before you replace the
lamp.
The lamp and the lamp glass
cover can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
21