JUNO JB096B5 Benutzerinformation Seite 18

18
• Clean the appliance interior after each
use. Fat accumulation or other food
remains may result in a fire.
• Clean stubborn dirt with a special oven
cleaner.
• Clean all accessories after each use and
let them dry. Use a soft cloth with warm
water and a cleaning agent.
• If you have nonstick accessories, do not
clean them using aggressive agents,
sharp-edged objects or a dishwasher. It
can cause damage to the nonstick
coating.
Stainless steel or aluminium
appliances
Clean the oven door with a wet
sponge only. Dry it with a soft
cloth.
Do not use steel wool, acids or
abrasive materials as they can
damage the oven surface. Clean
the oven control panel with the
same precautions.
Removing the shelf supports
To clean the oven, remove the shelf
supports.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
1
Install the shelf supports in the opposite
sequence.
Pyrolysis
CAUTION! Remove all
accessories and removable shelf
supports.
Do not start the Pyrolysis if you
did not fully close the oven door.
In some models, the display
shows "C3" when this error
occurs.
WARNING! The appliance
becomes very hot. There is a
risk of burns.
CAUTION! If there are other
appliances installed in the same
cabinet, do not use them at the
same time as the Pyrolysis
function. It can cause damage
to the appliance.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with hot
water, so that the residues do not burn
from the hot air.
3. Set the Pyrolysis function. Refer to
"Oven functions".
flashes.
4. You can use the End function to delay
the start of the cleaning procedure.
5. Press or turn the knob for the
temperature clockwise to start the
cleaning procedure.
Time of the procedure: 2 h.
During the Pyrolysis the oven lamp is
off.
2