Led Status Indicator; Factory Default Settings - Legrand Wattstopper Plus Installationsanleitung

The DPBC features a SELECT Button and LED Indicator. The SELECT Button enables you to
identify a device and reset to factory default settings. The LED Indicator has 4 states.

LED Status Indicator

LED Status
OFF Device is without mains power
Slowly Blinking Device is not yet or no longer part of a mesh network
Rapidly Flashing RESET successfully completed
Permanently ON Device is part of a mesh network

Factory Default Settings

Press and hold the SELECT button for approximately 10 seconds. The LED Indicator will blink for 2 seconds and the DPBC is reset to
factory default settings. This needs to be done before securing the faceplate onto the switch.
NOTE: This will delete the DALI short address and require the device to be re-commissioned.
FEATURES
Meaning
3
Remarks
Indication of RESET / Out-of-the-box state
After 3 seconds LED will change to Slowly Blinking
SELECT Button
LED Indicator