Power Probe PP3 Benutzerhandbuch Seite 8

pp3
ACTIVATING ELECTRICAL
WIGROUND (PPM)
Contact the probe tip to the negative terminal of the component, the LED
indicator should light RED While observing red positive sign "+" LED,
quickly depress and release the power switch rearvvard(-). If the red
indicator went out and the green negative sign (-) came on you may
proceed with further activation. If the green indicator went off at that
instant or if the circuit breaker tripped, the Power Probe has been
overloaded This could have happened for the following reasons:
• The contact is a direct positive vo tage
• The component is short-circuited
• The component is a very high current component (i e., starter motor)
If the circuit breaker tripped, reset it by allowing it to coo down (15 sec )
and then depress the reset button
WARNING: With this function,
circuit, a vehicle's fuse can be blown or tripped if you apply ground
to it.
Motor
TRICK:
When poweringup components. you
can increase the life Ofyour power
Probe switch if you fi rst press the
switch,then contact the tip to the
component. The arcing Will take place
at the tip instead of the contacts of
the switch
COMPONENTS
if you are contacting
7
7
the rocker
switch
to ground the horn
a protected