Power Probe PP3 Benutzerhandbuch Seite 12

p p3
Mode #5 Threshold
Power Probe Mode" (Mode #1)
This mode is only used to adjust the threshold voltage in "Power Probe
Mode" for Peak to Peak Detection and Signal Monitoring. To set the
threshold level for the peak to peak detection in "Power Probe Mode", press
and hold the mode button for one second until you hear a beep Repeat this a
second, third and forth time and/or until an alternating positive (+) and
negative ( ) sign is present in the bottom left corner of the LCD display
You can now toggle the threshold level by a quick tap of
the mode button and observing the voltage eve settings. The peak to peak
threshold voltage settings oop incrementally from 0.2, to 0 5, to 1.0, to 2.0, to
5 0, to 10 0, to 50 0 and return back to 02 again AN audio installer would
find the 0.2v setting convenient. Once you select the desired threshold
voltage, press and hold the mode button again until it beeps.
This returns you to the "Power Probe Mode" (Mode #1) You will know that you
are in the "Power Probe Mode" when the LCD display is blank and/or with
the "Speaker Symbol" shown in the bottom right corner.
Navigation
r Probe
is to the
batt«y a 12-24
volt supply, it
To enter
you hear a low
To enter into press
hold Mode 'Neon unbl
To
Mode unu
To into
& uode button
a nid tvd
To return to gode
haw until ym
Level Setting for the Peak to Peak Detection
Mode* Display
#1
#2
#3
&
#5
11
Mode/ Function Output
the ave-age
Power Mode•_
Audio Tane On
the peak
to Peak AC
Cm.it Breaker
thal
wth Audio
probe Mode:
Lint tod to
Cta_it
wth Audio
Captures the
Peak to
Captures the
Positive Peak to
the different *
Pea k to Peak Mode
tage
peak to Sets the peak
toAC
11
in
Mode 5