Silvercrest SWKP 3100 A1 Kurzanleitung Seite 13

Do not bend over the kettle when you
open the lid and the contents are still
hot. There is a danger of being scalded
by escaping steam.
The kettle becomes very hot during op-
eration. Only touch it at its handle and
only use the release button and the on/
off switch.
The device is fitted with non-slip silicon
feet. Because furniture can be coated
with a wide variety of varnishes and
plastics, and treated with various care
products, the possibility cannot be ex-
cluded that some of these substances
have ingredients that may attack and
soften the silicon feet. If necessary,
place a non-slip mat under the device.
Fill the device with a minimum of 0.5 li-
tres of water, as otherwise the device
may overheat.
Never put alcohol, sugar or milk into
the kettle!
Place the device on a stable, flat sur-
face.
Do not use any astringent or abrasive
cleaning agents.
Water as foodstuff
Water is a very sensitive foodstuff and can go
bad due to germs forming. Please take note:
• Always use fresh drinking water in the
kettle 2.
• Pour water away, which has been
standing in the kettle 2 for longer than
approx. 1 hour.
• Do not reboil cooled down water.
Before using for the first
time
1. Fill the kettle 2 up to the marking
MAX 1.7L on the water level display 3
and heat the water.
2. Pour the water out and rinse out the ket-
tle 2 with fresh water.
3. Repeat this process. Then it is safe to
use the device.
Boiling water
1. Remove the kettle 2 from the device
base 5.
2. Press the release button 9 to open the
lid 10.
3. Fill the kettle 2 with fresh drinking water
- minimum 0.5 litres, maximum
1.7 litres. Keep it upright or place it on
an even surface to be able to read the
water level display 3 correctly.
4. Close the lid 10, by pressing it down-
wards.
5. Place the kettle on the device base 5.
6. Insert the mains plug 6 into a readily
accessible earthed wall socket whose
voltage matches the voltage stated on
the rating plate.
7. Press the on/off switch 7 down, until it
lights up and locks into place.
8. The device automatically switches off as
soon as the water starts to boil, or when
you remove the kettle 2 from the device
base 5.
9. Disconnect the mains plug 6 from the
wall socket.
10.Remove the kettle 2 from the device
base 5 and pour the water out.
NOTE: to interrupt the cooking process,
press the on/off switch 7 up.
11
GB