Trotec TTK 140 S Originalbetriebsanleitung Seite 42

Cleaning the air filter
Notice
Ensure that the air filter is not worn or damaged. The
corners and edges of the air filter must not be
deformed or rounded. Before reinserting the air filter,
make sure that it is undamaged and dry!
The air filter has to be cleaned as soon as it is dirty. This is
brought to light e.g. by a reduced capacity (see chapter Errors
and faults).
1. Remove the air filter from the device.
2. Clean the filter using a slightly damp, soft, lint-free cloth. If
the air filter is heavily contaminated, clean it with warm
water mixed with a neutral cleaning agent.
3. Allow the filter to dry completely. Do not insert a wet filter
into the device!
4. Reinsert the air filter into the device.
B - 42
Emptying the condensation tank
(TTK 140 S / TTK 170 S / TTK 350 S)
1. Set the on/off switch (11) to position 0 to switch the device
off.
2. Remove the condensation tank.
3. Empty the condensation tank.
dehumidifier TTK 140 S / TTK 170 S / TTK 350 S / TTK 650 S
Info
The compressor always starts with a delay. This
protects the compressor and thus increases its
lifetime. If you remove the condensation tank from the
device and reinsert it after emptying, the compressor
will switch back on with a delay of approx. 20 seconds.
This delay is also enabled in optional hygrostat
operation. If the room humidity exceeds the setting of
the selection switch, the compressor will only switch
back on after a delay.
Depending on the compressor, the fan keeps running.
If the condensation tank is removed, the device does
not switch off.
EN