Installing The Scsi Backplane Daughter Card In A Poweredge 2850 System - Dell PowerEdge 2800 Handbuch

Installing the SCSI Backplane Daughter Card
in a PowerEdge 2850 System
1
Unpack the SCSI backplane board daughter card kit.
2
Turn off the system, including any attached peripherals, and disconnect the system from
the electrical outlet.
3
Remove the bezel (if applicable).
4
Open the system.
5
Grasp the plastic tab on the back of the control panel cable and pull the cable connector away
from the backplane connector. See Figure 1-2.
NOTE:
If you pull on the control panel cable harness, you may damage the harness.
The SCSI backplane daughter card connector and card guide are located in the compartment
below the control panel cable.
Figure 1-2. Installing a SCSI Backplane Daughter Card
control panel cable
retention lever
retention peg
on card
control-panel connector on backplane
SCSI daughter card
backplane connector
SCSI backplane
SCSI daughter card guide
SCSI daughter card
Installing the SCSI Backplane Daughter Card
1-5