Dell PowerEdge 2850 serie Handbuch Seite 8

Redundant Power-Supply Indicator Code Update
Table 1-3 correctly identifies the redundant power-supply indicator codes. See your Installation
and Troubleshooting Guide for more information about the redundant power supply.
Table 1-3. Power-Supply Indicator Codes
Indicator
Power-on
Fault
Power present
Changing the LCD Display of the System ID and Name
To change the LCD display of the system ID and name, enter the System Setup program as
described in the User's Guide and select Embedded Server Management from the main setup
screen. Then, in the screen that opens, select User-Defined, and under User Defined LCD String:
enter the desired system ID for Line 1 and system name for Line 2.
LCD Status Messages Update
Table 1-4 lists updates to the LCD status messages that can occur and the probable cause for
each message. The LCD messages refer to events recorded in the system event log (SEL).
For information on the SEL and configuring system management settings, see the systems
management software documentation.
Table 1-4. LCD Status Messages
Line 1 Line 2
Message Message
SYSTEM SYSTEM NAME
ID
6
Information Update
Indicator Code
Green indicates that the power supply is operational.
Amber indicates a problem with the power supply (fan failure, voltage error,
etc.).
Green indicates that power is present at the power supply and that the system
is connected to a power source.
Causes
SYSTEM ID is a unique name,
five characters or less, defined by
the user.
SYSTEM NAME is a unique
name, 16 characters or less,
defined by the user.
The system ID and name display
under the following conditions:
• The system is powered on.
• The power is off and active
POST errors are displayed.
Corrective Actions
This message is for information
only.
You can change the system ID
and name in the System Setup
program. See your User's Guide
for instructions.