Dell PowerEdge 2850 serie Handbuch Seite 10

Table 1-4. LCD Status Messages (continued)
Line 1 Line 2
Message Message
E0780 PROC n PRESENCE
E07F0 PROC n IERR
E07FA PROC n THERMTRIP Specified microprocessor is out
E0876 PS n MISSING
PS n STATUS
E0876 PS n PREDICTIVE
E0876 PS n AC LOST
PS n AC RANGE
8
Information Update
Causes
Microprocessor is not installed
in socket n.
Faulty or improperly installed
microprocessor.
of acceptable temperature range
and has halted operation.
No power available from the
specified power supply; specified
power supply is improperly
installed or faulty.
Power supply voltage is out of
acceptable range; specified power
supply is improperly installed or
faulty.
Power source for specified power
supply is unavailable, or out of
acceptable range.
Corrective Actions
Install a microprocessor in
socket n. See "Replacing a
Processor" in your Installation
and Troubleshooting Guide.
See "Troubleshooting the
Microprocessors" in your
Installation and Troubleshooting
Guide.
See "Troubleshooting System
Cooling Problems" in your
Installation and Troubleshooting
Guide. If the problem persists,
ensure that the microprocessor
heat sinks are properly installed.
See "Replacing a Processor"
in your Installation and
Troubleshooting Guide.
NOTE:
The LCD continues to
display this message until the
system's power cord is
disconnected and reconnected to
the AC power source, or the SEL
is cleared using either Server
Assistant or the BMC Management
Utility. See the Dell OpenManage
Baseboard Management
Controller User's Guide for
information about these utilities.
See "Troubleshooting Redundant
Power Supplies" in your
Installation and Troubleshooting
Guide.
See "Troubleshooting Redundant
Power Supplies" in your
Installation and Troubleshooting
Guide.
Check the AC power source
for the specified power supply.