Operating Principle; Possible Uses; Before Using - EINHELL 23.691.00 Bedienungsanleitung

Anleitung LEF 200 M 20.02.2006
Read these instructions carefully and
keep them in a safe place.
Features
Moisture extraction
10 l per day (at a room temperature of 30 °C and
80% humidity).
Automatic cut-out when the water tank is full.
When the water tank is full the water level indicator
shines with a red light and the unit switches off
automatically.
Active carbon filter
To curb the proliferation of bacteria and to absorb
dust particles.

Operating principle

Condensor
Evaporator
Humid
air
Condensed
water tank
Compressor
The dehumidifier controls the relative humidity of the
inlet air. The humid air condenses on the cooler
elements and is transferred to the water tank. The
dry air is heated a little on the condenser and
returned to the room.

Possible uses

Too high a level of humidity is not good for either
yourself or your home. With the LEF 200 M you can
create an agreeable and healthy climate in
basements, storage rooms, fitted cupboards,
pantries, kitchens, libraries, galleries, strong-rooms,
computer rooms, archives, living-rooms and
7:18 Uhr Seite 7
bedrooms.
Note:
70% humidity is the upper limit with which humans
feel comfortable. If it feels too warm then the water
content is too high, i.e. the humidity is too high.
Humidity has a certain relationship to temperature.
As a general rule the following applies: 60-70% for
summer and 50-70% for winter.

Before using

The room temperature should lie in the range
from 5 to 35°C. The dehumidifier will not work
effectively outside this range.
Room heating
Initially the dehumidifier creates heat,
causing the room temperature to rise by a
possible 1-2 °C.
Important safety information:
The dehumidifier should always be used in
vertical position.
After transporting or tilting (angled positions) the
device, do not plug into the power socket for at
least 1 hour.
There should be an air gap of approx. 15 cm on
all sides of the unit so that it can draw in enough
Dry air
air.
Keep the unit away from heaters or heat-
generating equipment.
Never pour or spray water over the unit.
Never use the power plug to switch the unit on or
off.
Always use the switch on the control panel.
Before you move the unit, switch it off with the
On/Off button, pull out the power plug and empty
the water tank.
Clean the air filter before it becomes heavily
soiled. The unit works best with a clean filter.
Never use insect spray or any other combustible
cleaning agents on the unit.
If the unit develops a fault, switch it off, pull out
the power plug and notify your service partner.
If the power cable suffers any damage,
it must be replaced by a specialist in order to rule
out all risks.
Using for the first time
Check that the voltage from the mains power supply
is the same as the voltage indicated on the rating
plate. Connect the plug to the 230 V ~ 50 Hz power
socket. The "Power" LED lights up.
GB
7